Assembly - Proflex XTR5 User Manual

XTR5 Elliptical Cross Trainer

Assembly

1. Take all parts out of the carton and place them on a firm, flat surface. Remove all packing materials.
Check that all parts have been supplied. Note that some parts, such as the feet, have the necessary
fasteners pre-assembled – these will need to be removed during the assembly process.
2. Attach the front foot (has wheels) (2) and rear foot (3) to the main body (1). Attach the feet using the
pre-assembled captive bolts (4), curved washers (5) and acorn nuts (6). Ensure that the bolts are
inserted from the outer side of the feet. Tighten (rotate right) the nuts firmly.
3. Bring the centre brace (7) near its location on the main body and connect the wiring in the main body
and centre brace together (A). Do not remove the rubber band holding the wiring at the top of the
centre brace (B) at this stage. Additionally, ensure that the tension adjuster is in the "1" setting (C) – the
tension cable will be at its longest at this setting.
7
4. Join the tensioning cables in the centre brace and main body together. The "ball" (D) on the end of the
centre brace tensioning cable must sit in the "hook" (E) in the connection bracket on the end of the main
body tensioning cable. Once the cable end is hooked into position, pull the cable collar (F) up and over
the slot (G) at the top of the cable connection bracket.
D
Slide the centre brace down over the main body – ensure that not cables or wiring are pinched or
5.
caught. Secure the two parts together using the 4 pre-assembled screws (8) and curved washers (9).
Firmly tighten (rotate right) all fasteners using the Allen key.
E&OE
6
4
5
A
E
F
© 2017 Proflex
3
1
B
E
G
8
2
C
D
9
5