Ricoh LD220F Operating Instructions Manual page 178

4. Monitoring and Configuring the Printer
• Specify the IPv4 address to destination.
"0.0.0.0" cannot be specified as destination address.
Enabling/disabling specified IPv4 destination
msh> route active {host|net} "destination" {on|off}
• If you do not specify {host|net}, the host setting is automatically selected.
Adding IPv4 Routing Table
msh> route add {host|net} "destination" "gateway"
• Adds a host or network route to "destination", and a gateway address to "gateway" in the table.
• Specify the IPv4 address to destination and gateway.
4 • If you do not specify {host|net}, the host setting is selected automatically.
• You cannot specify"0.0.0.0" as the destination address.
Setting the Default IPv4 Gateway
msh> route add default "gateway"
Deleting specified IPv4 destination from Routing Table
msh> route delete {host|net} "destination"
• If you do not specify {host|net}, the host setting is automatically selected.
• IPv4 address of destination can be specified.
Setting IPv6 Default Gateway
msh> route add6 default gateway
Adding a specified IPv6 destination to Routing Table
msh> route add6 "destination" "prefixlen[1-128]" "gateway"
• Specify the IPv6 address to destination and gateway.
• If the prefix of the address is between 1 and 127, the network is selected. If the prefix of the
address is 128, the host is selected.
• You cannot register a record that has the same destination and prefix as a registered record.
• You cannot register a record that uses "0000:0000:0000:0000:0000:0000:0000:0000" as
its destination.
Deleting a specified IPv6 destination from Routing Table
msh> route delete6 "destination" "prefixlen"
• Specify the IPv6 address to destination and gateway.
Display information about a specified IPv6 route information
msh> route get6 "destination"
• Specify the IPv6 address to destination and gateway.
176