Daikin DCM601A51 Installation Manual page 3

English
01_EN_3P291714-1.indd 3
When wiring the power supply and connecting the remote controller wiring and trans-
mission wiring, position the wires so that the electric parts box lid can be securely fas-
tened.
Improper positioning of the electric parts box lid may result in an abnormal heat build-up,
electric shock, or fire.
Be sure to earth the unit.
Do not earth the unit to a utility pipe, lightning conductor or telephone earth lead.
Imperfect earthing may result in electric shocks or fire.
Do not change the protective equipment settings.
Otherwise, a short-circuit may occur in a pressure switch, temperature switch, or other
protective equipment, forcing the unit to operate unexpectedly.
In addition, use of parts other than those specified by DAIKIN may result in firing.
Install an earth leakage breaker, as required.
Failure to install an earth leakage breaker may result in electric shocks or fire.
Be very careful about product transportation.
Safely dispose of the packing materials.
Tear apart and throw away plastic packaging bags so that children will not play with
them.
If children play with a plastic bag which was not torn apart, they face the risk of suffoca-
tion.
This unit is a class B product.
In a domestic environment, this product may cause radio interference. In such case, the
user may be required to take adequate measures.
Fill the wiring through hole with putty.
Entry of water or insects may result in electric leakage or malfunction.
Do not operate with wet hands.
An electric shocks and malfunction may be caused.
Do not wash this unit with water.
An electric shock or fire may be caused.
Install the indoor and outdoor units, power cord, and connecting wires at least 1 meter
away from televisions or radios.
This is to prevent picture interference and noise. (Depending on the incoming signal
strength, a distance of 1 meter may not be sufficient to eliminate noise.)
Do not install the unit in the following places.
1. Where there is a high concentration of mineral oil spray or vapor (e.g. a kitchen).
Plastic parts will deteriorate, parts may fall off and water leakage could result.
2. Near machinery emitting electromagnetic radiation. Electromagnetic radiation may
disturb the operation of the control system and result in a malfunction of the unit.
3. Where flammable gas may leak, where there is carbon fibre or ignitable dust suspen-
sions in the air, or where volatile flammables such as paint thinner or gasoline are
handled. Operating the unit in such conditions may result in fire.
4. High temperature area or directly flamed point. Abnormal heat build-up or firing may
be caused.
5. Moist area, or place where may be exposed to water. If water enters inside the unit,
an electric shock and malfunction may be caused.
Installation Manual 3P291714-1
DCM601A51 intelligent Touch Manager
WARNING
CAUTION
3
5/18/2011 1:45:48 PM