Arming While Driving - Avital 5303 Owner's Manual

To select the security levels:
Press once: The siren chirps once. The system is armed.
Press a second time within fve seconds. The siren chirps twice
followed by a long chirp. Zone 2 is now bypassed.
�������
Press a third time within fve seconds: The siren chirps three times
followed by a long chirp. Zone 4 is now bypassed.
�������
Press a fourth time within fve seconds: The siren chirps four times fol-
lowed by a long chirp. Zones 2 and 4 are now bypassed.
�������
Press a ffth time within fve seconds: The siren chirps fve times fol-
lowed by a long chirp. All input zones, except the ignition, are now
�������
bypassed.
Note: Multi-Level Security Arming only applies to a single arming
cycle. Once the system is disarmed and then re-armed, all the
�������
zones will be active again.

Arming while driving

Your security system can be armed while driving the vehicle.
Press on the transmitter for two seconds while the vehicle is running.
The siren will chirp once to indicate that the security system is armed,
and then once more to indicate that the ignition is on. The system will
not respond to any input except the door triggers, and the starter kill
relay (if installed) will not be activated. Once you have arrived at your
destination, the system will disarm when the ignition is turned off. The
�������
siren will chirp twice and the LED will then stop flashing. The system can
also be disarmed at any time by pressing
22
.
© 2011 Directed Electronics. All rights reserved.
�������