Omnia 11 Quick Start Installation Manual page 8

sysTEm CONFIGURATION
1. Touch the "FM Options" button (JJ) on the left side of the
Menu Area and ensure that the Pre-Emphasis, Diversity
Delay (if present) and BS-412 settings are correct for
your system and your location.
2. Touch the appropriate button (KK) above the "FM
Options" button to select the group of output controls
for the output you will be using. All outputs are active
simultaneously. Note: If you are using a conventional
AES/EBU L/R digital output to feed an FM exciter or
linear STL, touch the "AES/EBU" button and be sure the
"Output Selection" is set to "FM" and the "De-emphasis"
is turned "OFF" for the output being used. For access to
the composite MPX stereo generator output level and
stereo pilot controls, touch the "Composite" button.
Note that these controls simultaneously adjust the
Omnia Direct output levels as well. Finally, adjust the
appropriate control so that the peak output/modulation
level is correct for the equipment that follows the
Omnia.11.
3. Touch the "FM" icon button (LL) at the top of the screen
and then touch the "Preset" tab (MM) to display the list
of factory processing presets. If the preset list is locked
(grayed-out), touch the "padlock" icon to unlock it. Once
unlocked, simply touch the desired preset name in the
list and it will be put directly "on the air". We recommend
listening to all factory presets to get a feel for their
differences and then select one to start with.
4. Touch the "Quick Setup" tab (NN) and adjust the
following controls to set the basic loudness, bass and
brightness sound desired.
5. A djust the "Clipper Drive" control (OO) as low as
possible for the loudness needed. This controls the
primary loudness vs. distortion tradeoff. Turning it up
makes the sound louder (but more distorted) while
turning it down makes the sound cleaner but not as
loud. It should always be set as low as possible for the
level of loudness required.
6. Set the overall amount of bass using the "Bass" control
(PP). At higher settings of the "Bass Thump" (QQ)
control, the "kick" or "Thump" action of bass material
is emphasized.
7. Set the basic brightness of a preset by using the
"Presence" (RR), "Treble" (SS) and "Sparkle" (TT)
controls. Note that these three controls only boost the
brightness. A setting of "0.0" is "flat" or the minimum
amount of boost for the particular preset that is
currently selected. Reducing brightness can be done,
for one example, by reducing the higher bands of the
AGC or Limiter mixers.
yOUR sETUP Is COmPlETE!
That's it! You are now ready to experience the Omnia.11
for sound like never before.
© 2016 TLS Corp., All Rights Reserved.
(CONT.)
KK
JJ
LL
MM
NN
OO
PP
RR SS
1490-00099-001 — QUICK START GUIDE: OMNIA.11 C16/15035
QQ
TT