Omnia 11 Quick Start Installation Manual page 6

NETWORK CONFIGURATION
S
U
lIVEWIRE CONFIGURATION
1. Once the system has rebooted, touch the "Setup"
button (S).
2. Touch the Livewire button (T). The Livewire
configuration screen will be displayed (U).
3. If you do not have a Livewire system, make sure
the 2 Livewire output channels are disabled. The
2 "Enable" buttons (V) will be white if Livewire
is disabled and green when enabled. To disable
Livewire, touch each of the two green "Enable"
buttons (V) to turn them white.
4. If you do have a Livewire system, enable Livewire
by touching each of the two "Enable" buttons (V) to
turn them green.
5. If you have a Livewire system, touch the white fields
(W) next to the Output #1 and #2 and enter the
appropriate channel value via the pop-up keyboard (X).
6. Touch the "APPLY" button (Y) under the Outputs.
7. Touch the white fields (Z) next to the Input #1 and #2
to enter the appropriate channel value via the pop-
up keyboard (X).
8. Touch the "APPLY" button under the Inputs (AA).
CONTINUE TO sysTEm CONFIGURATION
Network configuration is complete. Your system is
ready for system configuration. Continue to the "System
Configuration" instructions.
T
Z
AA
(CONT.)
X
W V
Y