Omnia 11 Quick Start Installation Manual page 4

AUdIO CONFIGURATION
G
a. For Analog audio, connect XLR audio cables to the left and right ANALOG OUTPUTS jacks (F).
b. For Digital audio, connect XLR audio cables to the AES OUT 1/2 jacks (G).
c. For a direct composite MPX connection, connect an XLR cable to the AES COMPOSITE OUT jack (H).
Note: If you will be using conventional AES/EBU L/R digital audio to feed your STL or FM exciter, be sure
any pre-emphasis and limiters (if present) are fully defeated in the exciter. The Omnia must be the only
device providing the pre-emphasis so its own de-emphasis on the AES/EBU output being used must
also be "Off". Also note that if the STL uses a codec (is not linear), the Omnia must be located at the
transmitter site for best performance and sound quality.
d. For an existing Livewire system, the single Livewire Ethernet connection is all that is needed for audio I/O
(except for the composite MPX outputs). IMPORTANT: Do not connect an Ethernet cable at this time.
2. Make sure that no cables are plugged into either Ethernet port.
3. Connect the Omnia.11 to AC Mains (I).
4. Once the system has booted up completely, connect one end of the Ethernet cable to the top Livewire/100BT
port (J) on the back of the Omnia.11. Connect the other end of the Ethernet cable to a configured Ethernet
switch (K) to allow access to the network.
CONTINUE TO NETWORK CONFIGURATION
Your audio connections are complete. Continue to the "Network Configuration" instructions.
AUDIO OUTPUT - All outputs are active simultaneously.
F
(CONT.)
H