Using The Docking Station; Using Multimedia Cards; Using The Navigation Button - Psion Teklogix netpad 16M User Manual

netpad
user guide

Using the Docking Station

The Docking Station is used to charge the netpad and to provide additional
communication links for data transfer.
Connect the Docking Station to the supplied power source. Place the netpad in the
Docking Station until the release button clicks and it will begin charging. To remove the
netpad, press the release button and lift out. The yellow LED indicates communications,
while the red LED indicates charging/power, and the green LED indicates a fully charged
unit.
��������������
��������
You can rotate the orientation
of the Docking Station on
its stand. Hold the top of
the Docking Station in
one hand and the bottom
in the other. Lift the top
part to release it and
rotate through 90°.
When you let go of the
top part, it will click into place.
����������������� �������������
�����
���������������������
��������������
���������������������������
���������������������������
�����������������������
����������
10

Using Multimedia Cards

netpad supports a single Multi Media Card (MMC) as removable storage media.
The MMC can be used to store application software and/or data.
To fit an MMC, open the card slot
door located on the side of the
unit by sliding the retaining
latch and swinging the door.
Push the MMC into place until it
clicks. Close the door and slide the
latch back.
To remove an MMC, open the door and push
the card. Store your MMC safely, particularly
if it contains valuable data.

Using the Navigation Button

The function of the Navigation Button and Programmable Function Keys is dependant
on the software application installed on the netpad. Please refer to the software
application's operating instructions for details of how to use of the Navigation Buttons and
Programmable Function Keys.
11
��������������
��������
�����
������