netpad
user guide
Switching on and off
netpad can be switched on by tapping the touch screen (refer to ON/OFF in Control
Panel on page 7). There is also an On/Off switch located on the top side of the unit.
�������
�������������
To switch off, press the On/Off switch.
You can switch off at any time and do not have to save your information.
By default, if you do not use the netpad it will switch off automatically after a short time
to save battery power. Simply switch back on and continue from where you left off.
(The time for automatic switch off can be modified via the Control Panel.)
4
���������������
�����������������
�������
��������������
��������
���������
�� � ���
Finding and using the Stylus
The stylus is located in a holder just behind the screen (refer to the diagram on page 4).
To remove it, pull it out of the holder. To replace it, slide it back, point first.
To navigate using the stylus, tap lightly on the screen. You can also use your fingers to tap
on the screen but this may leave fingerprints or smudges.
Do not use any object that has a sharp or hard tip, or any type of ink pen — you may
damage the screen.
5