Polycom Full Duplex Conference Phone and Wireless Microphone System Installation Instructions Manual page 10

To place the call on hold or mute
At any time during a phone call, press
HOLD HOLD
call on , or simply press on the remote keypad. This shuts off the speaker and all
HOLD
microphones. The display will show
HOLD
To take the phone off press only the
remote keypad. To shut off the microphones while keeping the speaker on, simply press
MUTE .
The display will show MUTE and the LED's will turn from green to red. To take the phone off
MUTE MUTE
, press on either keypad.
To redial the last phone number called
Press the redial key. The display on the main keypad shows the last phone number which you
have called or attempted to call.
ON/OFF
NOTE: The key
does not have to be pressed
REDIAL
for to operate.
To make a 3-way conference call or to transfer a call to another extension
(if enabled on your telephone system)
FLASH
Once a call is in progress, press the
A second dial tone will be heard and the display will read
extension and hang up the phone by pressing
the second phone number. Once connected, press
be connected.
NOTE: To hold a conference
call with more than three
parties, a conference call
service provider (such as
Confertech, AT&T, MCI and
Sprint) is required, or contact
your telecom manager.
SoundStation Premier Full Duplex Conference Phone and Wireless Microphone User's Guide
SHIFT , then press MUTE on the main keypad to place a
and all LEDs begin blinking red.
MUTE HOLD
key on the main keypad or
key.
FLASH . To transfer the call, dial the
ON/OFF . To make a 3-way conference call, dial
FLASH
again, the two other parties will now
To program and use One-Touch dialing
NOTE: The main keypad does
not enable One-Touch
dialing.
When the phone is off, up to six phone numbers can be stored from the remote keypad.
To program One-Touch dialing phone numbers, press
connected to a PBX, press either 8 or 9, then press
the PBX can access an outside line). Next, type in the desired phone number, then press
STORE
side of the remote keypad, there is a place to record these phone numbers.
To use 1-Touch dialing, simply press any of the six stored phone number locations. There is no
need to press
on the
NOTE: If no PBX exists,
PAUSE
is not required.
To mute all microphones, press
To resume two-way communications, press
return to green.
MUTE
A local
By switching to the
will be shut off. Switching to the 1 position will turn the microphone back on.
, and finally press the desired location to store this phone number, 1-6. On the reverse
ON/OFF .
MUTE
:
MUTE again. The blinking red LED will
button is located on each of the extended microphones:
O MUTE
position, the LED light will turn red and only this microphone
SoundStation Premier Full Duplex Conference Phone and Wireless Microphone User's Guide
PROG . If the SoundStation Premier is
PAUSE (this inserts a two second delay so