JVC KW-NT1J Service Manual page 17

(2) Remove the A worm gear, M connect gear and M wheel
gear by sequentially. (See Fig.16)
A worm gear
M connect gear
M wheel gear
(3) Remove the two screws G attaching the Loading motor.
(Se Fig.17)
G
(4) When attaching the Loading motor, motor wire should arrange
to figure. (See Fig.18)
Wire arrangement
3.2.10 Removing the Roller assembly (See Fig.19)
(1) Remove the Slit washer.
(2) Remove the R middle gear.
(3) Remove the R connect gear.
(4) Snap off the part a of the Roller assembly.
(5) Lift up the part b of the Roller assembly, and then release
part c (When release part c, R collar R is easy to come off,
does not lose it).
CAUTION:
When reattach the Roller assembly, Middle gear should keep
direction and Slit washer should be change new part.
Fig.16
Fig.17
Fig.18
R middle gear
Direction
Slit washer
b
part
3.2.11 Removing the Roller (See Fig.20)
(1) Remove the Slit washer.
(2) Pull out the Roller shaft.
CAUTION:
When reattach the Roller shaft, Slit washer should be change
new part.
slit
keep direction
R collar R
R connect gear
c
part
a
part
Fig.19
keep direction
slit
small side
Fig.20
(No.MA453<Rev.003>)1-17