Advertisement
INSTALLATION INSTRUCTIONS, CONTINUED
COMMUNICATIONS ADJUSTMENT, Continued
Page 2-5
unit,
IlliC-1ST,
will be
"SET"
regardless of true input level.
In Type
C
Systems,
the input level indicator of the studio unit, the RMC-1SS,
15
relative to the sub-
audible frequency component of the incoming signal.
CONTROL OUTPUT
LEVEL
ADJUSTMENT--Unless otherwise instructed, adjust the out-
put h :vel of the remote control studio unit, RMC-1SS, to the middle of the
"SET"
range.
Counting turns will help you find the mid-point.
CONTROL
INPUT LEVEL
ADJU5TMENT--Turn
the
input level on the remote control
transmitter unit, {{MC-IST
,
down to a "LO" indication.
Turn the input level adjust-
ment clockwise. three or four turns beyond where the "SET" level is first indicated.
TELEHETRY OUTPUT ADJUSTMENT--In normal operation, telemetry is on in
all
channels other than channel
zero.
TYPE
~--Adjust
the output level of the remote control transmitter unit,
RMC-
1ST, to the midd le
0
f
the
"SET"
range for
0.8
VAC RMS.
TYPE
~-
-For
wire-line telemetry, adjust telemetry output as in Type A above.
If
using
SeA,
consult the manufacturer's instructions for input requirements and
adjust the output level while monitoring the input terminals of the SeA generator
with an external voltmeter.
For TSL adjust the output level to middle of set range.
Consult TS1 Manual for instructions on setting of modulation level.
TYP£ f--With no program audio, set the subaudible carrier level using the
station modulation monitor.
This is 6% on an AM station and 25% (1KHz deviation)
on a 67 KHz SeA subcarrier.
Do not depend
On
the output indicator of the remote
control because this indication mayor may not be appropriate.
Restore normal pro-
gram audio and adjust the "ATTEN" pot on the insertion board for 8S% maximum negative
peaks On the AM station monitor or 857.
0.4
KHz Deviation) of FM SeA.
In channel zero,
modulation characteristics should
be
normal.
TELEMETRY
I
N
PUT
AOJUS THENl'
TYPE
~--With
telemetry on, turn studio unit input pot down to a "LO" indication.
Turn th
e
input level adjustment clockwise several turns beyond
where the "SET" level
Advertisement
