Capsule And Battery Installation - Lectrosonics HHa Quick Start Manual

Capsule and Battery Installation

A common threaded mount allows the use of a variety of different capsules from
different manufacturers. Capsules are attached with a right-hand thread
The threaded interface is a 1.25"
opening with 28 threads per inch and
three contact rings
To remove the batteries, pull the eject lever
outward. the battery tips will move outward,
making them easier to grasp.
2
A mic capsule is
threaded onto the body
of the transmitter in the
direction shown.
Do not overtighten it.
To insert batteries, close
the eject lever and insert
the upper contacts
first (closest to the mic
capsule). Polarity is
marked on the label in
the bottom of the battery
compartment.
downward until it engages the
Do not touch the contacts between the mic capsule
and transmitter body. When necessary, the contacts
can be cleaned with a cotton swab and alcohol.
LECTROSONICS, INC.
The lower housing opens
by rotating it in the direction
shown. After the threads are
disengaged, pull the housing
detent that holds it open.
To remove the windscreen
from the mic capsule, line
up the blue wrench (that
was included with your
unit) with the flat notches
on the lower threaded area
of mic capsule.