Water Line - Sub-Zero 18" Installation Manual

IN S TA L L AT I O N
Alignment
AN CHO R I NG
Adjust the depth of the unit to fit flush with surrounding
cabinetry. Once aligned, verify doors and drawers open
properly, then install screws in each side trim.
SCREW
SIDE TRIM
CABINETRY
FACE
FRAME
PANEL FRONT OF
THICKNESS UNIT
Anchoring.

Water Line

For model IW-30CI, approximately 3'
tubing is connected to the unit with a preassembled
compression connection under the unit. The water line fit-
ting connection kit, provided with the unit, contains a
compression union fitting for connection to the household
water line.
Purge the water line prior to final connection to the unit. This
will remove any debris that may be present in the tubing
from installing the new water line. Connect the plastic tubing
from the unit to the house water supply line with the fitting
connection kit provided. Locate the water line in the notch
as shown in the illustration below. Check all water line fit-
tings for leaks.
If a reverse osmosis system used, it is
IMPORTANT NOTE:
recommended that the water filtration system be bypassed
by removing the filter.
IMPORTANT NOTE: Water lines can not be exposed to
freezing temperatures.
NOTCH
WATER LINE
CONNECTION
W ater line (IW-30CI).
1
of / " plastic
(.9 m)
4
1 / "
4
1
/ "
4
|
subzero.com 9