PowerBox Systems GPS II Instruction Manual page 7

Optimised for speed measurement:
In this mode the GPS receiver is optimised for rapid speed changes and best pos-
sible three-dimensional speed detection. This is the default setting.
Optimised for position detection:
In this mode the GPS receiver is set up for maximum positional accuracy. Speed
detection is slightly less rapid.
Settings according to the telemetry system in use:
iGyro: clicking on this option selects the M-Link telemetry system, and resets all
settings.
Multiplex M-Link: you can access Address Configuration to arrange the sequen-
ce of the values as displayed on the transmitter.
Maximum values can also be generated; these are switched off by default.
Alarms are set up at the GPS II using Alarm Configuration.
Futaba S-BUS 2: no configuration possible; all alarms are set up at the trans-
mitter.
Jeti EX BUS: alarms can be entered both at the GPS II and at the transmitter.
Graupner HoTT: alarms are set up at the GPS II.
www.powerbox-systems.com 7