Placing Calls - Polycom CX700 User Manual

User Guide for the Polycom CX700 IP Phone

Placing Calls

Note
3 - 2
If you require additional information or assistance with your new phone,
contact your system administrator.
You can place a call in many ways using your Polycom CX700 IP phone:
• Dial the number using the dial pad with the handset off-hook or on-hook.
• Select a contact from the contacts list shown on the graphic display.
• Select a contact from the contacts list using the Scroll Wheel, then press the
Select key (at the center of the Scroll Wheel).
During a call, you can alternate between Handset, Headset, or Speakerphone
modes by pressing the Speakerphone or Headset keys, or picking up the
handset.
Call duration on an active call is monitored through a local call timer. This is
visible within the active call window on the graphic display. In the figure
below, the call to Peter Krebs has just started.
You need to log in to place all outgoing calls or answer incoming calls. With regard
to the placement of emergency calls, consult your system administrator.
Only four simultaneous calls can be displayed on the graphic display at any time.
To place a call using the handset:
>> Do the following steps in any order:
— Pick up the handset.