Key To Symbols; Symbols On The Machine - Husqvarna DXR250 Operator's Manual

Symbols on the machine

WARNING! The machine can be a
dangerous tool if used incorrectly or
carelessly, which can cause serious or
fatal injury to the operator or others.
Please read the operator's manual
carefully and make sure you understand
the instructions before using the machine.
Noise emission to the environment
according to the European Community's
Directive. The machine's emission is
specified in the Technical data chapter
and on the label.
Always wear:
• Tight-fitting, heavy-duty and
comfortable clothing that permits full
freedom of movement.
• Sturdy, non-slip boots or shoes.
• Protective gloves.
• Protective helmet.
• Hearing protection.
• Protective goggles or a visor.
• A breathing mask, gas mask or fresh air helmet must
be used when working in environments where the air
can be harmful to health.
WARNING! Live parts.
WARNING! Ensure that no material can
fall down and cause damage when you
are using the machine.
WARNING! Watch out for demolition
material becoming loose when cutting.
Use personal safety equipment and keep
your distance.
WARNING! Always position yourself
above the machine when driving on a
slope. There is a risk of the machine
tipping.
WARNING! Exercise particular caution
when working close to edges. Ensure that
the machine is stable and does not move
closer to the edge while the work is in
progress. Ensure that the underlying
surface has satisfactory bearing capacity.
Inspections and/or maintenance must
be carried out with the motor switched
off and the power cord disconnected.
Always connect the machine
through an ground fault circuit
interrupter with personal protection,
i.e. an ground fault circuit
interrupter that trips at an ground fault of 30 mA.
2 – English

KEY TO SYMBOLS

Ensure that the power cable cannot
be run over. Take particular care
when moving or when the
outriggers are being retracted or
extended. Risk of electric shock.
The lifting equipment must be attached at
all the machine's lifting points.
Keep your distance! Nobody is permitted
to be within the machine's risk area when
work is underway. The machine's risk area
can vary during the course of the work.
The machine can overturn during
work. During operation the machine
must be positioned as level as
possible and the outriggers must be
fully extended.
Environmental marking. Symbols on the
product or its packaging indicate that this
product cannot be handled as domestic
waste.
By ensuring that this product is taken care
of correctly, you can help to counteract the
potential negative impact on the environment and people
that can otherwise result through the incorrect waste
management of this product.
For more detailed information about recycling this
product, contact your municipality, your domestic waste
service or the shop from where you purchased the
product.
Option: Cooling kit
Compressed air
Pressure
Gearbox oil
Drain
Hydraulic oil