Table of Contents
Advertisement
Programming A Rolling Code
NOTE:
For programming Garage Door Openers that were manufactured after 1995. These Ga-
rage Door Openers can be identified by the "LEARN" or "TRAIN" button located where
the hanging antenna is attached to the Garage Door Opener. It is NOT the button that
is normally used to open and close the door. The name and color of the button may
vary by manufacturer.
1. Place the ignition switch into the ON/RUN position.
2. Place the hand-held transmitter 1 to 3 inches (3 to 8 cm) away from the HomeLink
button you wish to program while keeping the HomeLink indicator light in view.
3. Push and hold the HomeLink button you want to program while you push and hold
the hand-held transmitter button.
4. Continue to hold both buttons and observe the indicator light. The HomeLink indica-
tor will flash slowly and then rapidly after HomeLink has received the frequency signal
from the hand-held transmitter. Release both buttons after the indicator light changes
from slow to rapid.
5. At the garage door opener motor (in the garage), locate the "LEARN" or "TRAIN-
ING" button. This can usually be found where the hanging antenna wire is attached to
the garage door opener motor. Firmly push and release the "LEARN" or "TRAINING"
button.
NOTE:
You have 30 seconds in which to initiate the next step after the LEARN button has been
pushed.
6. Return to the vehicle and push the programmed HomeLink button twice (holding the
button for two seconds each time). If the device is plugged in and activates, program-
ming is complete.
NOTE:
If the device does not activate, push the button a third time (for two seconds) to com-
plete the training.
7. To program the remaining two HomeLink buttons, repeat each step for each remain-
ing button. DO NOT erase the channels.
ELECTRONICS
95
Advertisement
Table of Contents
