Table of Contents
Advertisement
WHAT TO DO IN EMERGENCIES
ESC Full Off
This mode is intended for off-highway or off-road use only and should not be used on
public roadways. In this mode, all TCS and ESC stability features are turned OFF, except
for the limited slip feature described in the TCS section. To enter the "Full Off" mode,
push and hold the ESC OFF switch for five seconds. After five seconds, the ESC OFF
Indicator Light will illuminate, and the "ESC OFF" message will display in the EVIC. To turn
ESC ON again, momentarily push the ESC OFF switch.
– Park/Headlight ON Indicator
This indicator will illuminate when the park lights or headlights are turned on.
- Power Steering System Warning
This light is used to manage the electrical warning of the EPS (Electric Power Steering
System). When the ignition is turned to the MAR position, the warning light will illuminate
momentarily. If the warning light stays on, cycle the ignition to the STOP position and
back to MAR. If the warning light stays on, contact your authorized dealer.
If the warning light switches on while driving, you may not have steering assistance. Al-
though it will still be possible to steer the car, the effort needed to operate the steering
wheel could be increased: contact an authorized dealer as soon as possible.
– Defroster Indicator
Indicates that defroster is on.
Change Engine Oil
•
Your vehicle is equipped with an engine oil change indicator system. The "Change En-
gine Oil" message will flash in the EVIC display for approximately 10 seconds after a
single chime has sounded to indicate the next scheduled oil change interval. The engine
oil change indicator system is duty cycle based, which means the engine oil change in-
terval may fluctuate, dependent upon your personal driving style.
•
Unless reset, this message will continue to display each time you turn the ignition
switch to the MAR position. To turn off the message temporarily, push and release the
MENU button. To reset the oil change indicator system (after performing the sched-
uled maintenance), refer to the following procedure:
1. Turn the ignition switch to the MAR position (Do not start the engine).
2. Fully depress the accelerator pedal slowly, three times within 10 seconds.
3. Turn the ignition switch to the STOP position.
NOTE:
If the indicator message illuminates when you start the vehicle, the oil change indicator
system did not reset. If necessary, repeat this procedure.
107
Advertisement
Table of Contents
