Table of Contents
Advertisement
9
Accessories & Options
Accessories & Options
9.1
A-frame (Optional)
9.2
Remote Antenna (Optional)
9.3
Loc-10Tx Vehicle Power Lead (Optional)
9.4
Loc-10Tx Outdoor Power Supply (Optional)
9.5
LPC Separation Filter (Optional)
The A-frame accessory is used to detect ground faults on pipes and
cables. In the case of pipes, the faults consist of coating defects. In the
case of cables, faults are usually caused by insulation damage allowing
the metallic sheath (or internal conductor) to become in contact with the
ground.
The remote antenna can be used to help identify a particular cable on a
cable tray or where cables are bunched together.
12V DC, 30ft (10m) lead to power the transmitter from a vehicle.
Note, this is NOT a charge lead.
If it is intended to apply the transmitter to a target line at high output
levels and long periods, it may be useful to power the transmitter using
the 12V DC vehicle power lead. To power the transmitter from the 12V
DC vehicle power lead, connect the lead to the 12V DC input positioned
on the side of the transmitter. Plug the cigarette lighter plug into the
vehicle cigarette lighter socket (be sure that the socket is live. Some
vehicles only activate the cigarette lighter when the vehicle is running).
It is not necessary to disconnect or remove the standard batteries as
the unit will automatically select the external 12V DC supply.
12V DC, 30ft (10m) lead to power (NOT charge lead) the transmitter
from the mains supply.
Note, this is NOT a charge lead.
The LPC separation filter (LPC) is used to safely inject a trace tone to a
live cable via a domestic mains socket, so that the cable can be traced
from the premises to the connection in the street. It is suitable for
connecting to voltages between 100V AC and 250V AC.
Page 51
Advertisement
Table of Contents
