Table of Contents
Advertisement
3
vLoc-9800 Receiver
3.7
Setup Menu
A second function performed by the "i" pushbutton is to access the setup menu. Press and hold the "i"
pushbutton for two seconds to display the setup menu. Use the "+", "-" to navigate through the various
options and use the "M" pushbutton to select. To exit the setup menu, press the "i" pushbutton.
The setup menu allows the user to configure their personal preferences. This menu can be accessed and
changed at any time.
3.8
Frequency Selection
The vLoc-9800 receiver is capable of locating a number of frequencies. A list of these frequencies can be
accessed using the setup menu. The setup menu allows the operator to select the frequencies they wish to
use regularly. The frequency select pushbutton on the main receiver pad is used to toggle through the
frequencies defined in the setup menu. The operating frequency is shown in the information bar at the top of
the display. It is possible to change this selection at any time using the setup menu.
The initial frequencies set at the time the unit is supplied are "Power", "Radio", 982Hz, 9.8 kHz, and 83.1 kHz.
See the transmitter section for suggestions of which frequency is best suited to specific applications.
To select the frequencies you wish to use regularly, enter the setup menu by pressing and holding the "i"
pushbutton for 2 seconds. Use the "+" and "-" to select the word "Frequency" – then press the "M" pushbutton
to display the list of available frequencies.
The "+" and "-" pushbuttons are used to navigate the list of frequencies. To add a frequency to the
"Frequently used list" press the "M" pushbutton and a dot will appear in the circle alongside the frequency. To
deselect a frequency press the "M" pushbutton and the dot will disappear. Once your selection is completed
press "i" pushbutton once to return to the setup menu, and again to exit the setup menu.
3.9
Information Pushbutton (Depth & Current)
Pressing the "i" pushbutton will display the depth to the center of the radiated signal and a measurement of
the current (press the pushbutton briefly – remember if you press and hold, you enter the setup menu. If you
do enter the setup menu, press the "i" pushbutton again to return to the locating screen then try again).
If measuring the depth of a Sonde, ensure "Sonde" mode is selected otherwise the depth measurement will
be incorrect. Sonde mode has a different "Depth" screen and does not indicate current.
Pushbutton
Pushbutton
Page 11
Advertisement
Table of Contents
