Dual Frequency" Mode - Vivax vLoc-9800 User Handbook Manual

5 Loc-10Tx Transmitter
5.2.7

"Dual frequency" Mode

This feature can be used when user wants to energize on user's target two frequencies at the same time.
Mainly, it can be used when user is not sure which frequency can be impressed better into the target.
NOTE
When using "dual frequency" mode, total power will be split between the two
activated frequencies.
This mode of operation is available only for frequencies below 40 kHz.
The two frequencies have to be available in the main menu.
To enter the "Choose Second Freq." menu, proceeds as follows:
1. Press "f" pushbutton to select the lowest frequency that user want to have in the dual combination.
2. Press "i" pushbutton 4 times to get to the "Choose Second Freq." sub-menu. The above frequency will be
shown in a box.
3. By using the "+" and "-" pushbuttons, user can scroll through the available frequencies and bring the
wanted one in the box.
4. Press "f" pushbutton to select the second frequency and exit the submenu to return to the main display.
5. In the main display screen, both frequencies are displayed. The frequency will toggle between the two
chosen frequencies.
NOTE
If user is changing the selected frequency by pressing the "f" pushbutton, this
mode will be deactivated. To reactivate it, user has to follow again the above
procedures.
If the unit is powered down, this mode will be reset. To activate it again after
power up, user has to follow the above procedures.
Page 30