Preparing For Spraying - Micron Herbi-4 CDA Instruction Manual

Note:
a) Acoustic information:
exceed 70 dB(A).
b) Vibration: the weighted RMS acceleration value at the hands when using this
machine should not exceed 2.5 m/sec.

PREPARING FOR SPRAYING

The sprayer is delivered in a collapsed form. To assemble ready for spraying:
DIAGRAM 2
1) Extend the sprayer and securely connect the feed tube
2) Connect the male 3 pole connector
connector 5 and lock the both connector.
3) Remove the atomiser protective cover
disc spins freely.
4)Turn on the switch
3
N.B. Before spraying for the first time with the HERBI-4, the spray pattern
produced should be checked using only water (see 'BEFORE SPRAYING').
the sound pressure level at the operator's ear should not
from the lance to the tank female 3 pole
2
and check by hand that the atomiser
4
.
3
to the flow valve.
1