To Stopspraying - Micron Herbi-4 CDA Instruction Manual

It is best to hold the HERBI-4 to the side or the rear so that the operator does not have to
walk over the treated area.

TO STOPSPRAYING

Close the flow valve and then switch off the sprayer. When the atomiser disc has
stopped spinning raise the sprayer to an angle of 45° (see below). raise the spray
Never
head until the atomiser disc has stopped spinning. Then open the flow valve and drain
any remaining liquid in the feed tube back into the tank (by raising the feed tube above
the level of liquid in the tank). Then close the flow valve.
For ease of transport the tank can be disconnected (use the flow valve to isolate any
liquid left in a backpack) and the sprayer collapsed (OFF the switch and disconnect the
3 pole connector).
9