Initial Radio Setup - Becker BT45-BKR Quick Install Manual

Ground wire to radio chassis

Initial Radio Setup

Initial Radio Setup: : : : Initial Radio Setup Initial Radio Setup
One important step is enabling the AUX and Phone functions within
the Becker radio menu. Most Becker radios are pre-programmed to
recognize a CD Changer connection and because of that you must
perform the following steps and change that setting from CD
Changer to "AUX" otherwise the adapter will not perform as
intended.
Note: Note: Note: Note: Becker CDR210, CR210, PCM1 and others without "AUX" function
are not compatible.
Enabling the AUX and Phone Enabling the AUX Enabling the AUX Enabling the AUX and Phone function and Phone and Phone
Fig. 21 Fig. 21
Fig. 21 Fig. 21
function function function
Radios with TP button: (e. . . . g g g g . CDR Radios with TP button: (e . CDR- - - - 220)
Radios with TP button: (e Radios with TP button: (e . CDR . CDR
1. Turn radio "ON"
2. Press and hold the "TP" button for about 8 seconds until
Becker 1 is displayed.
3. Turn the Tuning Knob until AUX OFF is displayed.
4. Press either button located directly under the Arrows on the
display to change the present setting from OFF to ON.
Turn radio OFF.
5. Go to Tel Tel and select Ph On Ph On option
Tel Tel Ph On Ph On
6. Turn Radio back "ON" Press "S S S S " button to enter AUX Mode.
This is the mode to use whenever you want to listen to the
device connected to the adapter.
Radios with ☼ button: (
Radios with Radios with Radios with button: (e e e e . . . . g g g g . BE6104) button: ( button: ( . BE6104) . BE6104) . BE6104)
1. Turn Radio "ON"
2. Press and hold the ☼ button for about 8 seconds.
3. Select AUX "ON/OFF" option.
4. Press either button located directly under the Arrows on the
display to change the setting to ON.
5. Go to Tel and select Ph On Ph On option Ph On Ph On
6. Turn radio OFF.
7. Turn Radio back ON press the "☼" button until "AUX" is
displayed.
220)
220) 220)