Remote Control (Rcx003); Notes Of Remote Control Using; Operations; Basic Operations - Clarion CZ502 Owner's Manual & Installation Manual

Remote Control (RCX003)

[SRC/ ] Button • Repeat play
• Toggle the audio source
[MUTE] Button
• Power on ( short press) / off (long press)
• Mute the volume
[ , ] Buttons
[1~6] Buttons
• Preset station up / down
• [1] Button: Preset station 1.
• Previous / next track
• [2] Button: Preset station 2.
• Search (long press)
• [3] Button: Preset station 3.
[SCN/PS/AS] Button
• [4] Button: Preset station 4.
• [5] Button: Preset station 5.
• Scan play / Preset scan
• Auto memory store (long press) • [6] Button: Preset station 6.
[BAND/TOP] Button
[SOUND] Button
• MP3/WMA mode – Top play (long press)
• Sound effect setting
• HD RADIO mode – Select tuner band
• SIRIUS mode – Select tuner band/Select
category (long press)
[ , ] Buttons
• Volume up / down
[ ] Button
• Play / Pause
[SRC/ ]
[ISR] Button
• Recall ISR station stored in memory
[BAND/TOP]
• Store current station in ISR memory (long
press)
[
• iTunes Tagging (When connected with
HD Radio tuner and displayed "DIGITAL"
indicator and "TAG" indicator on display at
HD Radio-mode.)
[DISP] Button
• Display switch
[RDM] Button
• Random play
[RPT] Button

Notes of remote control using

Replacing the lithium battery of remote control unit.
When the range of the operation of the card remote control becomes short or no functions
while operating. Replace the battery with a new lithium battery. Make sure the battery polarity
replacement is correct.
1. Pull out the battery holder while pressing the stopper.
2. Insert the button-type battery with the stamped(+) mark facing upward.
Insert the battery holder into the remote control.
[ISR]
[ , ]
[SCN/
PS/AS]
[RPT]
[ ]
, ]
[SOUND]
[DISP]
[RDM]
[1~6]
[MUTE]
CR 2025
(CR 2025)

4. OPERATIONS

Basic Operations

Note:
• Refer to the diagrams in "3. CONTROLS"
when reading this chapter.
CAUTION
When the unit is turned on, starting and
stopping the engine with its volume
raised to the maximum level may harm
your hearings.
Be careful about adjusting the volume.
Power on / off
Notes:
• Start the engine before using this unit.
• Be careful about using this unit for a long
time without running the engine. If you
drain the car's battery too far, you may not
be able to start the engine and this can
reduce the service life of the battery.
1. Start the engine. The power button / knob
illumination on the unit will light up.
Engine ON
position
2. Press the [CONTROL] knob on the front
panel or [SRC / ] button on the remote
control to turn on the power under standby
mode. The unit goes back to the last
status after power on.
3. Press and hold the [CONTROL] knob
(center long press) on the front panel,
and rotate the [CONTROL] knob choose
POWER OFF, then press the [CONTROL]
knob on the front panel to turn off the
power.
Or press and hold [SRC / ] button on
remote control to turn off the power.
Mute
Press the [MUTE] button on the remote
control to mute the volume from the unit.
Note
:
Doing the operation above again or adjusting
volume will release muting.
Volume adjustment
Turn the [CONTROL] knob on the front
panel.
The adjustable range of volume is 0 to 40.
CAUTION
While driving, keep the volume level at
which external sounds can be heard.
Playing source selection
Press [CONTROL] knob on the front panel
repeatedly to choose desired playing source.
Notes:
• Playing source selection means selecting
work mode, such as RADIO mode and
AUX mode, etc.
Display system time
Press the [DISP] button on the remote
control to switch the display information,
system time and playing source.
RESET
Note:
* When the [RESET] button is pressed,
frequencies of radio stations, titles, etc.
stored in memory are cleared.
RESET
FZ502
4