Advertisement
ASSEMBLY
FIG.1
:
FIG.2
FIG.1:
Remove the bolts and nut from the
bottom tube, then attach the Front
Stabilizer (pt.15) to the Main Frame
(pt.16) using two sets of Ø8 Curved
Washers (pt.5), M8 Domed Nut (pt.6)
and M8*70 Carriage bolt (3).
Attach the Rear Stabilizer (pt.4) to the
Main Frame (pt.16) using two sets of
Ø8 Curved Washers (pt.5), M8 Domed
Nut (pt.6) and M8*70 Carriage bolt (3).
FIG.2:
Slide the Vertical Seat Post (pt.10)
into the seat post housing on the main
frame (pt.16). Then slide the Seat
Post (pt.12) into the Vertical Seat Post
(pt.10). You will have to slacken the
knurled
section
Adjustment Knob (pt.7) and pull the
knob back and then select and align
holes for the desired height. Release
the knob and retighten the knurled
portion.
Now fix the Seat (pt.13) to the Vertical
Seat Post (pt.12) as shown, and
tighten the bolts around the screws
under the seat.
4
of
the
Spring
Advertisement
