Create A Asa Logical Device Via Gui - Cisco Firepower 4110 Preparative Procedures & Operational User Manual

Cisco Preparative Procedures & Operational User Guide
Firepower /ssa/logical-device/mgmt-bootstrap/ipv4* # set ip ip_address
mask network_mask
h) Exit management IP configuration scope:
Firepower /ssa/logical-device/mgmt-bootstrap/ipv4* # exit
i) Exit management bootstrap configuration scope:
Firepower /ssa/logical-device/mgmt-bootstrap* # exit
6) Commit the configuration:
commit-buffer

4.5.7.2 Create a ASA Logical Device via GUI

1) Choose Logical Devices
The Logical Devices page shows a list of configured logical devices on the chassis. If no logical
devices have been configured, a message stating so is shown instead.
2) Click Add Device to open the
3) For the Device Name, provide a name for the logical device.
4) For the Template, choose
5) For the Image Version, choose the ASA software version.
6) For the Device Mode, click the
7) Click OK.
You see the Provisioning - device name window.
8) Expand the Data Ports
9) Click the device icon in the center of the screen.
The ASA Configuration dialog box appears.
10) On the General Information
a) On multiple module devices, like the Firepower 9300, choose the security module that you want to
use for this logical device by clicking on it under Security Module Selection.
b) Select the management interface to use with the logical device from the
drop-down list.
c) Under DEFAULT, configure the management interface:
This information is used to configure a management interface in the security module/engine
configuration. This management IP address is also the IP address you will use to connect to ASDM.
1 Select the type of address from the
2 In the Management IP
3 Enter a Network Mask
4 Enter a Network Gateway
11) On the Settings tab, enter a password for the "admin" user in the
12) Click OK to close the ASA Configuration dialog box.
13) Click Save.
© 2016 Cisco Systems, Inc. All rights reserved.
to open the Logical Devices page.
Add Device dialog box.
Cisco Adaptive Security
Standalone radio button.
area, and click each port that you want to assign to the device.
tab, complete the following:
Address Type
field, configure a local IP address.
or Prefix Length.
address.
Appliance.
Management Interface
drop-down list.
Password field.