Weapon Mount - ATN OTS-17 Operator's Manual

2.2.6. WEAPON mOuNT

To mount the ATN OTS-17 on the weapon perform the following:
1. Mount the weapon mount adapter (1) onto the Elcan mount
system (2) with two screws M4x7.
2. Slightly loosen the mounting screw (3) on the side of weapon
mount adapter.
3. Align the monocular and the scope mount adapter. Slide the
scope rearwards until the alignment boss aligns with the
alignment groove on the weapon mount adapter.
4. Tighten the mounting screw (3).
5. Slightly loosen the fixing screws (4) of Elcan mount.
6. Place the Elcan mount system on the dovetail mount of the
firearm making sure that the mount aligns with the receptor
attachment screw groove. Adjust as necessary.
7. Tighten the fixing screws (4) of Elcan mount.
4
2-8
3
1
2
Figure 2-7. Weapon mount