Table of Contents
Advertisement
Install CR123A Lithium batteries as follows.
1. Remove the battery cap by turning it counterclockwise.
2. Check to ensure the o-ring is present. If not, replace it.
3. Observe polarity, as indicated on the outside of the battery
compartment, and insert two 3.0 Volt CR123A Lithium bat-
tery into the battery compartment, minus (-) end first (Figure
2-1).
4. Replace battery cap by pushing and turning it clockwise.
Tighten it firmly to ensure a watertight seal.
2.1.2. EXAmINATION FOR OPERATION
Before getting started make sure to follow these steps:
1. Push ON-OFF button on the scope.
2. Make sure that the luminance in ocular is present.
3. Observe the scene, and adjust the diopter and/or lens for
optimal image clarity.
Figure 2-1. Install batteries
2-3
Advertisement
Table of Contents
