Safety Instructions - Electrolux EYL85016WM User Manual

6 www.electrolux.com
2.

SAFETY INSTRUCTIONS

2.1 Installation
WARNING!
Only a qualified person must install
this appliance.
Remove all the packaging.
Do not install or use a damaged appliance.
Obey the installation instruction supplied
with the appliance.
Keep the minimum distance from the other
appliances and units.
All products manufactured and supplied by
Electrolux are safe provided they are
installed, used correctly and receive regular
maintenance in accordance with these
instructions.
If you are in any doubt about your ability to
install this product safely you must employ
the services of an experienced qualified
plumber/electrically qualified person.
Do not operate the shower unit if you
suspect the water inside is frozen. Do not
site the shower unit where it might be
subjected to freezing conditions.
Do not install this shower unit in a
room/environment without adequate
ventilation or an extractor fitted. This is
required to prevent condensation forming
within the unit.
The unit must be mounted on the finished
wall surface (usually tiled). Under no
circumstances must you tile up to or seal
around the unit as this may prevent air
circulating and condensation escaping.
This shower unit must not be modified* in
any way as this will invalidate the guarantee.
* Except for those indicated on this manual
where the product has been designed to
be modified by the installer.
You must not fit a "water saving" handset
(whereby the flow of water can be
restricted or turned off) to the shower,
otherwise this can result in scalding and/or
unit failure.
Electrical connection
WARNING!
Risk of fire and electrical shock.
All electrical connections must be made by
a qualified electrician.
The appliance must be earthed.
Before carrying out any operation make
sure that the appliance is disconnected
from the power supply.
Use the correct electricity mains cable.
Do not let the electricity mains cable tangle.
Make sure the appliance is installed
correctly. Loose and incorrect electricity
mains cable or plug (if applicable) can
make the terminal become too hot.
Make sure that a shock protection is
installed.
Use the strain relief clamp on cable.
Make sure not to cause damage to the
mains plug (if applicable) or to the mains
cable. Contact the Service or an electrician
to change a damaged mains cable.
The electrical installation must have an
isolation device which lets you disconnect
the appliance from the mains at all poles.
The isolation device must have a contact
opening width of minimum 3 mm.
Use only correct isolation devices: line
protecting cut-outs, fuses (screw type
fuses removed from the holder), earth
leakage trips and contactors.
Always switch off the power at the
consumer unit and isolate the electrical
supply before making any electrical
connections or if you have to remove the
cover of an installed unit.
2.2 Use
WARNING!
Risk of fire and electrical shock.
Remove all the packaging, labeling and
protective film (if applicable) before first use.