Mode Setup; Video Tester - Test Equipment Depot Rapport 337 User Manual

◉ Mode Setup

•LCD Screen is changed in order of VIDEO
whenever key is pressed once.
•MODE SELECT window displays on LCD screen when
pressed more than 3 sec.
Press key after selecting the mode you want, using the shift setup
key.
•Video Tester Mode :
At this mode, the image quality of the external input picture signal is
tested, or the monitor, etc. is tested by using the picture signal that is
output from PATTERN GENERATOR mode.
•Digital Multimeter mode :
At this mode, voltage, current, & continuity are tested.
•PTZ Controller mode :
At this mode, the basic movement of up, down, right, left for PTZ is made,
and zooming & manual focus are adjusted.
•UTP Cable Tester mode :
UTP cable, direct & cross cable, disconnection, and short circuit are
tested.
17
•View Information mode :
At this mode, the basic information of RAPPORT337 can be seen.
(version, battery residual, communications protocol, & speed.)
METER PTZ UTP
•Main Setting mode :
At this mode, the basic setup of RAPPORT337 can be changed.
key is
(user's name, auto power off time, beeper, brightness, contrast, etc.)
HELP :

◉ VIDEO TESTER

Connect the output terminal of video output system to the video input
BNC of RAPPORT337.
Connect the video output BNC of RAPPORT337 to the video input
terminal of system.
HELP image relevant to the mode displays when the key
is pressed on for more than 2 sec. at each mode.
How to use each mode is explained at each HELP menu.
18