Philips CEM250 User Manual page 8

A A B B
A1 A2 A3 A4 A5 A6 A7 A8 A1 A2 A3 A4 A5 A6 A7 A8
B1 B2 B3 B4 B5 B6 B7 B8 B1 B2 B3 B4 B5 B6 B7 B8
A A
a a b b c c d d e e
Connector Connect to
1 MIC Microphone
2 REAR LINE Rear right
OUT R speaker
 REAR LINE Rear left speaker
OUT L
4 SUB OUT Subwoofer
5 ANTENNA Antenna
2
Cut off the bigger end of the supplied
standard connector.
3
Check the car's wiring carefully and
connect them to the supplied standard
connector.
12 EN
B B
a a a a
a a
b b
c c
d d
a a
b b
b b
b b
c c
d d
e e
c c
c c
f f
g g
h h
i i
d d
d d
1 Green/black strip Left speaker
(Rear)
2 White/black strip Left speaker
(Front)
 Gray/black strip Right speaker
(Front)
4 Purple/black strip Right speaker
(Rear)
e RED Ignition key +12V DC
when ON/ACC
f BLUE Motor/electric antenna
relay control lead/
Amplifier relay control
lead
g BLACK Ground
h ORANGE/ Illumination switch
WHITE
i YELLOW To the +12V car
battery which is
energized at all times
4
Connect the supplied standard connector
to the unit.
Attach the front panel
1
Insert the right side of the panel in the
chassis until it is correctly engaged.
2
Press the left side of the panel and point
the left hole at the left pillar.
3
Release the panel to engage the left side.
4
Attach the trim plate.
Mount in the dashboard
1
If the car does not have an on-board drive
or navigation computer, disconnect the
negative terminal of the car battery.
• If you disconnect the car battery in
a car that has an on-board drive or
navigation computer, the computer
may lose its memory.
• If the car battery is not disconnected,
to avoid short-circuit, ensure that bare
wires do not touch each other.
2
Remove the mounting sleeve with the
supplied disassembly tools.
3
Ensure that car dashboard opening is
within these measurements:
EN 1