Postscript Setup Options - Ricoh Fiery 3850C Configuration Manual

3
3-30 Performing Setup from the Control Panel

PostScript Setup options

PS (PostScript) Setup allows you to set defaults for the Fiery 3850C. Users can override
most of these defaults on a job-by-job basis. However, users printing from UNIX or
DOS command lines cannot override defaults from their applications. Therefore, you
must set defaults in PostScript Setup. For information about these defaults, see the
Printing Guide.
In the list of options that follows, default values, where applicable, appear in square
brackets.
Error Page
Yes/No [Yes]
Specify whether the Fiery 3850C should print the available portion of a print job when
it encounters a PostScript error. Select Yes to print the portion of the job that was
processed before the error occurred; select No to cancel the print job entirely when a
PostScript error is encountered. Leave this option at No unless you encounter printing
problems.
Def Resolution
600x600 DPI/1200x1200 DPI [600x600 DPI]
Specify the copier's print resolution for all jobs.