Table of Contents
Advertisement
2.2
Quick Installation
2-2
The following steps are for quick installation of your controller,
transportable memory module, and flash power module. These steps are
for experienced computer users/installers.
Installation,"
contains the steps for all others to follow.
Step 1.
Review all safety information provided with the server; then,
turn off the power to the server and all of the attached devices,
and unplug the server and the device power cords.
Step 2.
Open the cabinet of the host system by following the
instructions in the host system technical documentation.
Step 3.
Mount the transportable memory module on the controller.
Step 4.
Install the controller in the server and connect the SAS devices
or the SATA devices to it. Make sure that the cables you use
conform to all specifications.
Step 5.
Perform a safety check.
a. Make sure that all cables are properly attached
b. Make sure that the controller is installed correctly
c. Close the cabinet of the host system
Step 6.
Reconnect the power cords to the system and to all attached
devices.
Step 7.
Turn on the power to the system after you complete the safety
check.
ServeRAID Controller Hardware Installation
Section 2.3, "Detailed
Advertisement
Table of Contents
