Avaya 8800 Technical Configuration Manual page 25

avaya.com
2.3.4.2 Add IP Address and Routing Protocol
CLI Step 1 –Add IP address to VRF VLAN
CLI
ERS8000-1:5# config vlan <1..4094> ip create <ipaddr/mask>
ERS8000-1:5# config vlan <1..4094> ip <ospf|rip> enable
ACLI
ERS8000-1:5(config)# interface vlan <1..4094>
ERS8000-1:5(config-if)# ip address <ipaddr> <mask>
ERS8000-1:5(config-if)# ip <ospf|rip> enable
ERS8000-1:5(config-if)# exit
JDM (release 5.x) Step 1 – Go to VLAN -> VLANs -> (click on corresponding VLAN id) -> IP ->
Insert and add IP address and mask. After that, click on the corresponding routing protocol tab
that you wish to enable, i.e. RIP or OSPF.
VRF-Lite for Ethernet Routing Switch 8600 Technical Configuration Guide
April 2011 25