Fujitsu SPARC Enterprise M3000 Product Notes page 61

Oracle Solaris OS Issues and Workarounds for All Supported Releases (Continued)
TABLE 3-4
M4000
CR ID M3000 M4000
6529714 O
6530753 O
6531036 O O
6532215 O O
6565553 O
6611966
6674266
6588650 O
M8000
M9000 Description
O Warning messages occur while trying to
configure more than four PCIe Quad-
port Gigabit Ethernet UTP Low Profile
Adapter (X4447A-Z) or PCIe Dual 10
Gigabit Ethernet Fiber XFP Low Profile
Adapter (X1027A-Z) into one I/O Boat.
O Some of the PCI slots in the External
I/O Expansion Unit PCI slots are not
displayed during a normal boot
operation.
O The error message network
initialization failed appears
repeatedly after a boot net installation.
O volfs or dscp service may fail when
domain is booted.
svc:/platform/sun4u/dscp:defau
lt: Method
"/lib/svc/method/svc-dscp
start" failed with exit status
95.
svc:/system/filesystem/volfs:d
efault: Method or service exit
timed out. Killing contract
59.
O DR deleteboard(8) and
moveboard(8) operations might fail.
Example for messages on domain:
drmach: WARNING: Device driver
failure: /pci
dcs: <xxxx>
config_change_state: Hardware
specific failure: unconfigure
SB1: Device driver failure:
/pci
O On occasion, the system is unable to DR
after an XSCF failover or XSCF reboot.
Workaround
No workaround is available.
Use one of the following operations to
display all of the PCI slots.
• boot -r (at open boot prompt)
• devfsadm -C (at Oracle Solaris OS
prompt)
• cfgadm (twice at Oracle Solaris OS
prompt)
No workaround is available. This
message can be safely ignored.
Restart the service if the failure is
observed. To avoid the problem, issue
the following commands.
# svccfg -s dscp setprop
start/timeout_seconds=count:
300
# svccfg -s volfs setprop
start/timeout_seconds=count:
300
# svcadm refresh dscp
# svcadm refresh volfs
No workaround is available.
Try DR operations again.
No workaround is available.
Chapter 3 Information About Software 47