ATSG AXOD Update Handbook page 54

WEAR ON OIL PUMP SHAFT AND BEARING
Proper alignment of the oil pump and the valve body are mandatory to prevent premature wear of the oil pump
drive shaft and the bearing assembly located in the pump housing. When re-assembling the valve body and oil
pump, use the guide pins to assure proper alignment.
INTSTALLATION PROCEDURE:
1. Position the spacer plate on the pump housing, using a new gasket.
2. Insert valve body guide pin T86P-70100-A (.271" Diameter) and valve body guide pin
T86P-70100-B (.262" Diameter), as shown in Figure 44.
3. Install two "Torx" bolts and torque to 7 to 9 ft.lb.
4. Remove both guide pins.
5. Position the spacer plate on the valve body using a new gasket.
6. Insert two valve body guide pins T86P-70100-A (.271" Diameter, as shown in Figure 45.
7. Install two "Torx" bolts and torque to 7 to 9 ft.lb.
8. Position the oil pump on the valve body using a new gasket.
9. Insert pump body guide pin T86P-70370-A and valve body guide pin T86P-70100-C which is
.245" in Diameter.
10. Install two valve body to oil pump retaining bolts and torque to 7 to 9 ft.lb.
SERVICE INFORMATION:
Oil Pump Drive Shaft ...................................................................................... E6DZ-7B328-A
Pump Bearing With Integral Seal .................................................................... XF2Z-7G184-AA
Pump Body Guide Pin ..................................................................................... T86P-70370-A
Valve Body Guide Pin (.271" Dia. - 2 Required) ............................................ T86P-70100-A
Valve Body Guide Pin (.262" Dia.) ................................................................. T86P-70100-B
Valve Body Guide Pin (.254" Dia.) ................................................................. T86P-70100-C
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
FORD AXOD AND AXODE (AX4S)
54