Table of Contents
Advertisement
5.2
Mounting
Wall Mounting
1.
Use the mounting bracket to determine the position of the mounting holes. Drill the holes.
2.
Fix the mounting bracket onto the wall (mounting accessories not included).
3.
Proceed with the connection.
Corner Mounting
1.
Use the corner bracket to determine the position of the mounting holes. Drill the holes.
2.
Fix the corner bracket onto the corner (mounting accessories not included).
3.
Fix the mounting bracket onto the corner bracket using the including mounting accessories.
4.
Proceed with the connection.
Pole Mounting
1.
Fix the pole bracket to the pole (diameter max. 130-152 mm) using stainless hose clamps with a
length of min. 15 cm.
2.
Fix the mounting bracket onto the pole bracket using the including mounting accessories.
3.
Proceed with the connection.
Ceiling Mounting
1.
Use the ceiling bracket to determine the position of the mounting holes. Drill the holes.
2.
Fix the ceiling base bracket to the ceiling (mounting accessories not included). If the dome is to be
used outdoors, apply a thin layer of silica gel between the base and the ceiling to make the
connection waterproof.
3.
Fix the ceiling bracket to the base using the including mounting accessories. If the dome is to be
used outdoors, apply a thin layer of silica gel between the ceiling bracket and the base to make the
connection waterproof.
4.
Proceed with the connection.
6.
Connection
V. 02 – 18/07/2016
CAMTVI10
1
2
3
5
12 VDC power supply
network cable
RS-485 connection
©Velleman nv
Advertisement
Table of Contents
