How To Set Parameters Switch (On/Off); Factory Set - Nobel FCD 05 Instruction Manual

6. by pushing the button
7. when the cursor blinks on the digit to modify, push the button
8. repeat the same operations with other digits, whether required
9. push the button OK to confirm the modifications
10. proceed as explained for other modifications of other parameter or push the ESC per to leave the
modification menu
11. push the button ESC to go back to visualization of service
• during the modifications, the normal service is NOT interrupted.
NOTE:
• In modification menù, ref. to the timers, the digits visualized on the line (marked as Ta)
underneath the line of the time setting (marked as T), indicate the status of the present
counting of the time related to the selected timer
• time basis are :
• although the programmer allows to set values up to 19999, in the field of the max
allowable pressure drop (B5), let us remind that the real max allowable value is 100,
correspondent to a pressure drop of 1 bar (=100 kPa = max allowable value pressure
drop across the filter).
7.5.

How to set parameters switch (ON/OFF)

Proceed as follows to make any modifications of the parameters allowing only ON/OFF selection.
1. push the button ESC
2. push several times the button
3. push the button OK .
4. push several times the button
5. push the button OK , the pointer blinks on the notice "switch"
6. push the button to change selection between ON and OFF
7. push the button OK to save/confirm the modifications.
8. proceed with other modifications, if any, or push the button ESC to quit the modification menu.
9. push the button ESC to go back to the visualization of service
7.6.

Factory set

Parameter
time BACKWASH
B1
time RINSE
B2
B4 delay of the max differential pressure driving
B5-ON max differential pressure
B5-OFF Must be NECESSARLY the same of B5-ON
time of delay starting regeneration of column B
B6
after conclusion of regeneration column A (for -
DUAL arrangements only)
B19 working mode selection (for DT models only)
B19 working mode selection (for DP models only)
Parameter
Start of regeneration by time
B3 - 1
B3 - 2
B3 - 3
B3 - 4 Pulse function of parameters B3-1, B3-2 and B3-3

s.r.l.Milano - ITALY
INSTRUCTIONS MANUAL AUTOMATIC FILTERS
, move the cursor on the digit to modify
s = seconds (00,00 ÷ 99,95)
m = minutes (00:00 ÷ 99m:59s)
h = hours
until the pointer > indicates "set param"
until the required parameter (B74 or other) is visualized.
utilization
utilization
regeneration
"
"
Page 18 of 23
FCD-FACD-FFD /DT /DP /DT-DUAL /DP-DUAL
until thge desired digit appears
(00:00 ÷ 99h:59m)
set value
15.00 m
05.00 m
60.00 s
80 (equal to 0.8 bar)
80
10.00 s
OFF
ON
Day of time ON
M 00 : 01
- -- : --
- -- : --
OFF
do not modify !
time OFF
00 : 02
-- : --
-- : --
r.4
fcd-dp_mi-r4.doc –