How To Set Day And Time Of Regeneration; How To Set Time Of Phases, Delay, Pressure Drop Value - Nobel FCD 05 Instruction Manual

7.3.

How to set day and time of regeneration

The days of the week can be set one by one; they appear on the display in the weekly row: it
is possible to select (visualized the initial letter of the day) or not (visualized the symbol -).
The row and explanation of the symbols that appear on the display are :
M / -
The available digits to set the time are between 00:00 and 23:59; the symbol --:-- indicate
not any ON and/or not any OFF.
The regeneration starts at the time set on the line ON.
The time on the line OFF
on the line ON.
The programmer allows to set up to 3 regeneration per day (B3-1, B3-2, B3-3).
Proceed as follows to modify :
1. push the button
2. push several times the button
3. push the button
4. push several times the button
modification (B3 - 1 or other)
5. push the button
OK
6. by pushing the button
the week
7. push the button
8. by pushing the button
OFF)
9. when the cursor blinks on the digit to modify, push several times the
number appears
10. repeat the same operations with other digits, whether required.
11. push the button
OK
12. push the button
explained at above points 5 ÷11, or push the button
13. push the button
WARNING : parameter B3-4 is concerning the pulse function of the parameters
B3-1, B3-2 and B3-3; for a proper working of the whole system, this
parameter must be necessarily set on OFF position.
7.4.

How to set time of phases, delay, pressure drop value

Proceed as follows to modify :
1. push the button
2. push several times the button
3. push the button
4. push several times the button
5. push the button

s.r.l.Milano - ITALY
INSTRUCTIONS MANUAL AUTOMATIC FILTERS
T / - W / - T / -
MUST BE NECESSARILY SET
ESC
until the pointer > points "set param"
.
OK
until the display shows the parameter where to make the
, the blinking cursor will take place on the line of the days (D)
the cursor moves on the positions correspondent to the days of
to enable/disable
the cursor moves on the several digits of the hours (lines ON and
to confirm the modifications
to visualize other parameters which must be modified, and operate as
to go back to visualization of service.
ESC
ESC
until the pointed > points "set param"
.
OK
until the parameter to modify is shown (B1 or other)
.
OK
FCD-FACD-FFD /DT /DP /DT-DUAL /DP-DUAL
F / - S / - S / -
one minute later than the time
to leave the modification menu
ESC
Page 17 of 23
until the desired
r.4
fcd-dp_mi-r4.doc –