Residual Heat Indicator; Accessories - Siemens ER3A6AD70A User Instructions

For dual double-flame burners, the inner and outer
flames can be controlled separately. The available
power levels are as follows:
It is essential to ensure that all the burner parts and pan
supports are correctly installed for the appliance to
work correctly. Do not swap the burner caps around.
Always remove the pan supports carefully. When
moving a pan support, the pan supports next to it may
also move.
Elements
1 Ignition plug
2 Thermocouple
3 Burner ring
4 Burner cup
5 Burner cap

Residual heat indicator

Every hotplate on the hob has a residual heat indicator
that indicates whether it is hot or warm.
If appears in the display the hob is still hot. As the
•
hotplate cools down further, the display changes to
The display remains lit until the hotplate has cooled
sufficiently. Do not touch the respective hotplate if this
indicator is lit.
Inner and outer flame on
full power.
Outer flame on low power,
inner flame on full power.
Inner flame on full power.
Inner flame on low power.
œ

Accessories

Depending on the model, the hob may include the
following accessories. These can also be acquired from
the Technical Assistance Service.
These appliances can be combined with conventional
hobs of the same make, using the joint accessory. See
the catalogue for details.
--------
Code
HZ233720 Additional wok grid
HZ298113 Additional espresso maker grid for the
wok burner
The manufacturer accepts no liability if these
accessories are not used or are used incorrectly.
.
Getting to know your appliance
Additional wok grid
Only suitable for use on wok
burners with two or three
flames. Only use cookware with
a diameter of more than 26 cm,
griddle plates, clay casserole
dishes, paella pans, cookware
with rounded base, etc.
To extend the service life of the
appliance, we recommend using
the additional wok grid.
Additional espresso maker
grid
Only suitable for user on the
inner flame of the wok burner.
Use cookware with a diameter
of less than 22 cm.
en
11