Mitsubishi CP-W5000DW Quick Setup Manual page 10

BEFORE OPERATION
Remove the sticker and insert the print
paper between the rollers to feed it as
until the blue indicator at the front bottom
of the slide door illuminates.
straight.
Print paper
Blue indicator
may produce poor print quality.
replacing the print paper.
print paper. If you carry out the following
paper may be damaged.
Mount the front cover bin.
Insert the projections at the bottom of both sides of the
front cover bin along the guides at the bottom of both
sides of the slide door and then close the front cover
bin.
Guide
mounted correctly. Incorrect mounting may
cause paper jam.
Rollers
NOTE
NOTE
NOTE
Push the slide door to close.
Hold the holding slots in both sides and push the front
of the printer with both hands to close the slide door as
When a new paper is loaded and the slide door is
closed with the power turned on, the paper will be
automatically fed and cut. The printer ejects two pieces
of paper and displays "Ready 8x12" on the LCD.
to get your hands caught between the printer
and the slide door. Otherwise, you may get
injured.
slide door is closed, the print paper may
have not been installed correctly.
sure that the print paper has been installed
correctly. Then close the slide door again.
initialization before starting the feed-and-cut
operation. This is not a malfunction. Wait for
Installation of the print paper and the ink
ribbon is completed.
prevent jamming the strips at the print output
sure to throw away the paper strips in the
front cover bin.
the thermal head and the platen roller.
display "PAPER END" even when some print
paper still remains. This is not a malfunction.
10
CAUTION
NOTE
NOTE