Cannot Pair Devices; Cannot Connect Using Nfc; Power Is Turned Off - Denon Envaya DSB200 Owner's Manual

Contents

2 Cannot pair devices

Symptom
Cannot pair devices.

2 Cannot connect using NFC

Symptom
Cannot connect using NFC.

2 Power is turned off

Symptom
Power is turned off.
Preparation Connections
• Turn the power of this unit off and on again.
• Move the Bluetooth device to within 1 meter of this unit and then try again.
• Turn the power of the Bluetooth device off and on again.
• Check that the Bluetooth device is equipped with the NFC function.
• Check the position of the NFC antenna on the Bluetooth device, and touch the N mark on this
unit with the NFC antenna of the Bluetooth device. Keep the Bluetooth device in contact with
this device until the Bluetooth device responds.
• If the input of this unit is set to Bluetooth and no audio is played back for approximately 15
minutes, this unit automatically enters standby mode. Turn the power of this unit off and on
again.
• If the input of this unit is set to AUX and it is not operated for approximately 8 hours, this unit
automatically enters standby mode. Turn the power of this unit off and on again (AUX auto
standby function). To turn the AUX auto standby function off, press and hold the AUX button
for approximately 3 seconds when the input of this unit is set to AUX.
Playback Troubleshooting
Cause/Solution
Cause/Solution
Cause/Solution
26
Appendix
Page
Page
Page
Index
13
-
-
-
18
-
-