Denon Envaya DSB200 Owner's Manual page 17

Contents
4
Select "Envaya" from the list of devices displayed in
the screen of the Bluetooth device.
When pairing is complete and the devices are connected by
Bluetooth, an electronic sound is heard and the Bluetooth button
changes from blinking to lit.
%
• If "Envaya" is not displayed in the screen of the Bluetooth device, search
for devices on the Bluetooth device.
• If you are asked to enter a pass key in the Bluetooth device screen, enter
"0000".
Preparation Connections Playback Troubleshooting
5
Playback music on the Bluetooth device.
The music played back on the Bluetooth device is output from this
unit.
%
• If pairing fails, try again from step 2.
• If you want to pair other Bluetooth devices, repeat steps 2 to 5 for each of the
devices that you want to pair.
Note
• This unit remains in the pairing mode for approximately 5 minutes. If the pairing
mode of this unit is canceled before you have finished pairing, repeat the process
again from step 2.
• This unit cannot pair with Bluetooth devices that have a pass key other than
"0000".
2 Deleting Pairing Information
1
Press and hold the Bluetooth button for approx. 10
seconds until an electronic sound is heard.
All of the registered pairing information is deleted.
Note
• Even when an electronic sound is heard approximately 3 seconds after pressing
and holding the Bluetooth button, continue holding down the button.
16
Appendix
Index