Table of Contents
Advertisement
The parts required to assemble and
install the water filtration system
are included with the unit.
Thoroughly check the water filtra-
tion system for possible shipping
damage and parts loss. Also
inspect and note any damage to
the shipping carton.
Remove and discard (or recycle) all
packing materials. To avoid loss of
small parts, we suggest you keep
the small parts in the parts bag until
you are ready to use them.
Your safety and the safety of others are very important.
We have provided many safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING"
These words mean:
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell
you what can happen if the instructions are not followed.
Read all instructions before installing and using
your UltraEase™ Pivotal Whole Home Water
Filtration System. Follow all steps exactly to cor-
rectly install. Reading this manual will also help you
to get all the benefits from the filtration system.
All plumbing must be completed in accordance with
national, state and local plumbing codes. Local
code information can be obtained at your local pub-
lic works department. In Massachusetts, plumbing
code 248 CMR 3.00 and 10.00 shall be adhered to.
Consult with your licensed plumber.
Do not use with water that is microbiologically
unsafe or of unknown quality without adequate dis-
infection before or after the system.
The UltraEase™ Pivotal Whole Home Water
Filtration System works on water pressures of 30
Inspect Shipment
Packing List
Mounting Bracket
with Screws
Before You Start
4
Installation Adaptors
Clips
You can be killed or seriously injured if you don't
immediately follow instructions.
You can be killed or seriously injured if you don't
follow instructions.
psi (minimum) to 100 psi (maximum). If your house
water pressure is over the maximum, install a pres-
sure reducing valve in the water supply pipe to the
filtration system.
To condition all water in the home, install the filtra-
tion system close to the water supply inlet, and
before all other plumbing connections, except out-
side water pipes.
Do not install the filtration system outside, or in
extreme hot or cold temperatures. Temperature of
the water supply to the filtration system must be
between 40°F and 100°F. Do not install on hot
water.
Avoid installing in direct sunlight . Excessive sun
heat may cause distortion or other damage to non-
metallic parts.
Vent Tube
FIG. 2
Advertisement
Table of Contents
