Model WHADUS5 How to install, operate and maintain your Dual Stage Water Filtration System Do not return unit to store If you have any questions or concerns when installing, operating or maintaining your water filtration system, call our toll free number:...
Before You Start Read all steps and guides carefully before installing and using your water filtration system. Follow all steps exactly to correctly install. Reading this manual will also help you to get all the benefits from the water filtration system. Do not use with water that is microbiologically unsafe or of unknown quality without adequate disin- fection before or after the system.
Parts of the System Filter system assembly Water supply fitting Filtered water faucet for sink or countertop mounting Color coded 3/8" tubing to make all needed connections Filter change drip tray Materials and Tools Needed NOTE: Gather the required tools before starting installation. Read and follow the instructions provided with any tools listed here.
Installation Instructions Step A - Install Cold Water Supply Fitting Check and comply with local plumbing codes as you plan, then install a cold water supply fitting. The fit- ting must provide a leak-tight connection to the water filter 3/8" tubing. A typical connection using the included water supply fitting is shown in Figure 3A.
Installation Instructions Step C - Install Faucet 1. Insert one end of the 3/8" blue tubing into the push-in fitting on the bottom of the faucet. Push tubing through the collet and all the way into fitting. Full engagement is 3/4" length of tube into the fitting. 2.
Installation Instructions continued from the previous page Connect Tubing: 1. Use a sharp cutter or knife to cut the end of tubing square. 2. Inspect the end (about 1") of the tubing to be sure there are no nicks, scratches or other rough spots. If needed cut the tubing again.
Whirlpool Dual Stage Water Filtration System model WHADUS5 with replacement element pack ® WHEEDF conforms to NSF/ANSI 42 and 53 for the specific performance claims as verified and substan- tiated by test data.
Faucet Electronics Faucet Timer Inside the faucet base is a battery operated 6 month timer. An amber LED indicator is also located in the front of the faucet base. This LED will flash continuously after 6 months have passed. This indicates that it is time to replace the battery and filters. Battery Change To change the battery, complete the following steps.
All sales in Iowa require the following signature before consummation of sale. These signatures must be retained by seller/renter for 2 years minimum. Buyer/Renter __________________________________________________________ Date _________________ Seller ________________________________________________________________ Date _________________ Seller’s Address _______________________________________________________________________________ Seller’s Phone No. _____________________________________________________________________________ Product: Whirlpool Dual Stage Water Filtration System - Model WHADUS5 ®...