Table of Contents
Advertisement
Included:
Filter head, bracket & mounting screws
Filter cartridge
Pre-Installation Inspection
Thoroughly check the water filtration system for possible shipping damage and parts loss. Also inspect
and note any damage to the shipping carton. Remove and discard (or recycle) all packing materials. To
avoid loss of small parts, we suggest you keep the small parts in the parts bag until you are ready to
use them.
1. Close a water shutoff valve upstream from where you will install the filter, and activate the refrigerator
water dispenser to relieve pressure in the cold water supply tubing.
2. Install the water filtration system in the cold water supply tubing, where accessible for filter changes.
This could be behind the refrigerator, the cabinet under the sink, the basement, etc.
See flow direction arrows
on bottom side of filter head
Parts & Tools
Installation Location
1"
2"
1/4" tubing
from cold
water supply
INLET
NOTE: Be sure to allow a minimum space of 1-1/2" under
the system for removing the filter cartridge to change it.
Not Included:
Slotted and Phillips screwdrivers
Pliers and adjustable jaw wrench
Tubing cutter
mounting
screws (2)
OUTLET
5
1/4" tubing to
refrigerator
FIG. 2
Advertisement
Table of Contents
