Connecting The Terminal Block; Figure 2-9 Installing The Terminal Block - Siemens SIMATIC 505 User Manual

Field Wiring (continued)
Connecting the
Terminal Block
2-12 Installing the Module
To connect the terminal block to the module, follow these steps. (See
Figure 2-9.)
1. Align the terminal block with the edge card connector on the bezel.
2. Press firmly at both ends of the terminal block until it is seated.
3. Tighten the screws at the top and bottom. Do not over-tighten.

Figure 2-9 Installing the Terminal Block

SIMATIC 505 Interrupt Input Module User Manual