Connecting More Devices Through A Hub To The - Acer 700 Series User Manual

Connecting more Devices through a Hub to the

700
2-4
The AcerRouter 700 provides 4 repeater hub ports to allow up to 4 PCs or
Workstations to be connected to it directly. If you want to connect more devices, you
can connect an external hub to LAN port 1.
The uplink switch is used to set LAN port 1 as an uplink port. To set the uplink
switch:
Step 1
Plug one end of a 10Base-T LAN cable into Port 1 of the AcerRouter 700,
and the other end of the 10Base-T cable into any 10Base-T LAN port on a
hub.
Step 2
Turn the AcerRouter 700 over, and locate a small rectangular hole in the
bottom of the case. Set the switch to the Uplink position. See Figure 2-2.
Uplink Normal
Figure 2-2 Uplink Switch
Connect to Port 1
and set Uplink
switch to "Uplink"
Plug this end into
any port of a 10Base-T
repeater hub
Back
Bottom of AcerRouter 700
Front
AcerRouter 700 Series User Guide